24
4 Programming
English
2.3.3 Light Sensor behaviour
motor LED colour purple:
To make use of the light sensor, define its response to Sun light signals and Dawn/Dusk
light signals. There are 8 preset patterns available.
Note: After 15s. without input, the motor unit quits programming mode.
Please read the steps of this feature first before starting.
SET Light sensor behaviour
1. Press and hold the
OPEN
+
CLOSE
buttons until the LED on the motor unit slowly flash-
es white (after ~8s.) (First the LED will turn white continuously, keep the button(s)
pressed)
2. Repeatedly press
OPEN
or
CLOSE
until the LED on the motor unit is purple.
3. Shortly press the
OPEN
+
CLOSE
buttons to enter the feature menu,
4. The LED on the motor unit now flashes purple at the current setting:
5. Cycle through the options below using
OPEN
or
CLOSE:
LED
Dawn/Dusk
Sun
OPEN
CLOSE
OPEN
CLOSE
1x flash *)
Off
On
Off
Off
2x flash
On
On
On
On
3x flash
Off
Off
On
On
4x flash
On
On
Off
Off
5x flash
Off
On
On
On
6x flash
On
On
Off
On
7x flash
Off
Off
Off
On
8x flash
Off
Off
Off
Off
*) Default setting
6. Confirm and store setting by shortly pressing
OPEN
+
CLOSE
buttons.
7. The LED on the motor unit slowly flashes white again for 15 seconds: using the
OPEN
or
CLOSE
buttons another MENU 2 feature can be selected.
8. Otherwise, wait for 15 seconds or shortly press the
OPEN
+
CLOSE
buttons to quit
programming.
The LED on the motor unit switches off, the system is ready to use.
To quit programming at any time, repeatedly press the
OPEN
+
CLOSE
buttons
or wait for 15s.
Changes made at 5 will only be saved if confirmed by pressing the
OPEN
+
CLOSE
buttons
.
Summary of Contents for G-Motion
