Goelst G-Motion, Manual

Page: 25 / 44

21
4
200cm
English
Programming
SET / ERASE intermediate positions
1. Using
OPEN
or
CLOSE
buttons, move the curtain in a desired position, to set a new
intermediate position or to erase an existing one.
2. Press and hold the
OPEN
+
CLOSE
buttons until the LED on the motor unit slowly flash-
es white (after ~8s.) (First the LED will turn white continuously, keep the button(s)
pressed)
3. Repeatedly press
OPEN
or
CLOSE
until the LED on the motor unit is green.
4. Shortly press the
OPEN
+
CLOSE
buttons to enter the feature menu.
5. The LED on the motor unit now flashes green, at setting 1 (1x flash):
6. Cycle through the options below using
OPEN or CLOSE:
1x flash = intermediate position 1 (Default)
2x flash = intermediate position 2
3x flash = intermediate position 3
4x flash = intermediate position 4
5x flash = intermediate position 5
7. Confirm and store setting by shortly pressing
OPEN
+
CLOSE
buttons: The position is
stored as new
OR
as replacement in case of an existing position setting.
8. The LED on the motor unit slowly flashes white again for 15 seconds: using the
OPEN
or
CLOSE
buttons another MENU 2 feature can be selected.
9. Otherwise, wait for 15 seconds or shortly press the
OPEN
+
CLOSE
buttons to quit
programming.
The LED on the motor unit switches off, the system is ready to use.
To store another intermediate position, repeat § 2.2 entirely.
To quit programming at any time, repeatedly press the OPEN+CLOSE buttons or wait for 15s.
Changes made at 6 will only be saved if confirmed by pressing the OPEN + CLOSE buttons.
2.3 Light sensor
The advanced Goelst Light sensor offers
1)
Sun light
related sensitivity
2)
Dawn/Dusk
related sensitivity
3) detailed
behaviour
settings
Default setting for both Sun and Dawn/Dusk sensitivity is „Standard“
see § 2.3.1 and § 2.3.2
Default setting for overall behaviour is „Close at Dusk“.
see § 2.3.3.