B l u e B o x
GO Systemelektronik GmbH Faluner Weg 1 24109 Kiel Germany Tel.: +49 431 58080-0
Fax: -58080-11
Page 22 / 96
www.go-sys.de
3.7 CAN-bus Termination at the BlueBox
The CAN-bus is factory preset terminated. If you need to change the termination, open the housing
∗
and set
the respective termination switch to either
On
or
Off
.
3.8 Jumper Position RS-232/RS-485 and RS-485 Termination at the BlueBox
The serial interface of the BlueBox is factory preset to RS-232, unless requested otherwise by the customer.
If you need to change the jumper positions, open the housing
∗
and place the jumpers correspondingly.
If the BlueBox is factory presetted to RS-485, then the interface is terminated by the factory.
∗
see
Appendix F – Opening of a BlueBox Housing
