I S A – D a t a T r a n s m i s s i o n
GO Systemelektronik GmbH Faluner Weg 1 24109 Kiel Germany Tel.: +49 431 58080-0
Fax: -58080-11
Page 42 / 76
www.go-sys.de
10.1 Transmitting the BlueBox Data with BlueBox SQL Software
To transmit the data from the BlueBox to the PC, open SQL Software <File> <Get Data>.
When checking these items in the sensor selection field the following data will be transmitted to the PC:
configuration data of the BlueBox
the measurement data of all connected sensors (in case of Intensity for each the MVR
∗
of the raw spectrum)
the raw spectra and the absorbance spectra
the measurement data of the selected sensors (in case of the ISA for each the MVR* of
the raw spectrum)
If this check box is activated, all those values are transmitted automatically, which had
been recorded since the point in time of the last data transmission. This point in time is
determined by the most current data set of the data base.
Only for measurement data.
If this check box is activated, only those values are transmitted, which differs from the
previous value for a certain degree.
The value of this difference is determined in: BlueBox SQL <Options><Sensor Details…>
"Data transmission level" (see
Manual BlueBox PC Software
).
Only active, if the connection is established via modem or gateway.
Transmits the data to the PC.
∗
MVR
= Maximum digital Value of a Raw spectrum
BlueBox selection
Sensor selection field
(example)
to
on
ly
a
t d
is
abl
ed
A
ut
om
at
ic
"All extended data" must be
checked, otherwise no spec-
tra are transferred.
from
Software version: 4.2.0.0
