Technical Support:
53498_MAN_GP-DC_Install_Kit_vI
Go Power! DC Install Kit
Owner’s Manual
1. Warnings
Avoid all electrical hazards.
Disconnect batteries and electrical system from 120/240
VAC, or any other power source of electrical power, before attempting to install your
Go
Power! GP-DC Install Kit
.
Observe proper polarity
throughout the installation process.
Work safely.
Do not wear jewelry when working with electrical or mechanical equipment.
Use protective eyewear, gloves and apron when working with batteries.
Follow the safety precautions
of the battery manufacturer. Do not produce sparks when
working in locations where flammable gases or vapors exist. Shield skin and eyes from
battery acid. If skin, eyes or clothing comes in contact with acid rinse thoroughly with
water.
Avoid electrical shock
. Make sure all sources (inverter, shore power, generator) are
disconnected.
2. Installation Overview
Congratulations on becoming the owner of a GP–DC Kit. Please read and understand all
instructions before installing your new product for the easiest and safest installation.
Before installing kit, review the installation design with this DC kit Installation Manual.
Contact your Authorized Go Power! Dealer if in doubt as to this kit's suitability or
compatibility with your system. Retain this guide for future reference.
2.1 Disclaimer of Liability & Warranty
The conditions or methods of installation, operation, use and maintenance of this kit and
its solar module are beyond the control of Go Power!. Go Power! does not assume
responsibility and expressly disclaims liability for loss, damage, or expense arising from,
or in any way connected with such installation, operation, use, or maintenance.
Go
Power! does not cover labor or shipping for items returned.
3. Installation
1. The inverter fuse is to be mounted on the positive cable near the battery.
2.
Kits 2 – 5 only:
Cut the positive (red) cable according to desired location. Strip ½” to
¾” of insulation from the cables, and connect the fuse block as shown.
