B36
5
1
Machine Frame
5
Zero
Adjustment
Pin
9
Bending Sleeve
13
Bending Plates
2
Electricity Board Cap
6
Stirrup Pin
10
Retainer
14
Bending Flange
3
Switch
Adjustment
Pin
7
Straight Pin
11
Adjustment
spanner
15
Control Panel
4
Sensor Pin
8
Bending Pin
12
Machine Table
16
Foot Pedal
17
Plate
2.
MACHINE ASSEMBLY
•
Machine should be leveled on a solid ground.
Figure 2
•
Electricity connection of the machine should be made by competent technicians.
Explanation
Electricity Connection
For main electricity connection plug should be connected to supply line with a 5x4 mm²
isolated cable and then plugged into power outlet.
Grounding connection should be made for safety. Machine shouldn't be operated without
making grounding connection.
Connection of grounding line
The following procedures should be followed for this system.
Connect one end of the grounding to a copper wire (minimum 16 mm²) as it will enable
electrical conductivity. The other end should be either connected with a pipe that has a conductivity
capacity immerged into the ground (preferably into a humid ground) or the copper plate should be
buried into the ground as much as deep.
Figure 2:
Leveling the machine on a solid ground
