SRI FLIP TOP WORKSTATION
TOOLS REQUIRED FOR ASSEMBLY
Cordless drill with Phillips head Bit & magnetic extension,
3/8" Magnetic socket bit.
BEFORE ASSEMBLING WORKBENCH
Read through the assembly instructions to
Familiarize yourself with the order in which the
parts are assembled. We suggest that you clear
& vacuum the area where the bench is to be
assembled. It is important that the bench is
assembled in the same sequence as instructed.
HARDWARE & GMI COMPONENTS
All assembly hardware is provided.
STEP 1
STEP 2
ASSEMBLE BASE COMPONENTS
Attach modesty panel to legs as shown using
the provided 1/4-20 X 1/2” flange head bolts
Next attach the front brace as shown using
the provided same bolts.
CPU RACK & WIRE BLIND
Use 10-32 X 1/2” pan head Phillips to attach
the rear wire blind to the cpu rack as shown
bolting through the CPU rack into the threaded
fasteners installed in the wire blind.
Next, bolt the rack assembly to the leg as
shown using the provided 1/4-20 X 1/2” flange
head bolts.
FRONT BRACE
RIGHT LEG
LEFT LEG
MODESTY PANEL
CPU RACK
REAR WIRE
BLIND
CONNECT TOP TO BASE COMPONENTS
Place the work surface upside down on clean
floor. Position the base over the top as shown so
that the leg holes will align with the pre-installed
Threaded fasteners in the under side of the work
Surface. Attach legs with provided 1/4-20 x 1/2” flange
Head bolts. Use the #14 x 3/4” Lag screws to secure
Through the brace and into the work surface.
WIRE TRAY / MODESTY
Use the #10 x 5/8” SPAX to attach
the wire tray through the provided
holes in the modesty panel and into the work surface
to secure as shown. Depending the length of the
work station additional holes may be present.
1/4-20 X 1/2”
FLANGE HEAD BOLT
THREADED
INSERTS
1/4-20 X 1/2”
FLANGE HEAD BOLT
10-32 X 1/2”
PAN HEAD PHILLIPS
#14 x 3/4”
LAG SCREW
#10 x 5/8” SPAX
COARSE THREAD
PAN HEAD PHILLIPS
