G X 4 0 0
I N S T R U C T I O N M A N UA L
1 7
DISCONNECTING THE MICROPHONE
It is recommended that the microphone be left permanently connected to the GX400, but if it
must be disconnected, proceed as follows:
1. Using a small screwdriver, ease the rubber boot out of the cable entry hole and slide it along
the microphone cable away from the front panel.
2. Identify the plug locking lever, work the screwdriver blade behind it and press the lever
towards the plug body. At the same time gently pull the plug from the socket
(see diagram below).
NOTE:
If required, replacement microphones are available with plug and rubber boot
already fitted.
Cable
Cable entry hole
Screwdriver
Locking lever,
move to left to
release plug
