Installation
Set-up
1. Carefully open and unpack the iced tea
urn.
2. Inspect for damaged parts.
3. Clean and sanitize the urn before
operation. See
Cleaning Instructions
.
4. Place on a flat, level surface.
Assembly
Crathco valves (Model GTD3-C):
1. Install the handle into the slot opening in
the front of the urn and drop in valve from
the top with gasket preinstalled.
Other valve types:
1. Slide wing nut onto the valve seat and
install the C-ring.
2. For pinch tube style valves:
a. Install pinch tube and pull until it is
fully seated inside of the urn.
b. Pull the valve handle to the fully open
and locked position; then slide it over
the pinch tube until it is seated on the
valve seat.
3. With the valve seated onto the valve seat,
and at the correct vertical displacement,
tighten the wing nut until the valve is
firmly seated.
4. For pinch tube style valves, move the valve
handle to the closed position.
If you need help, call GMCW Technical Service
Department, (502) 425-4776 or (800) 695-4500 (USA &
Canada only) (Monday through Friday 8 AM - 6 PM
EST). Please have the model ready so that accurate
information can be given.
Prior authorization must be obtained from GMCW for
all warranty claims.
Operation
CAUTION:
Burn hazard. Water used for brewing
tea is very hot. Use caution when brewing, pouring, or
transporting hot tea. Never attempt to move the urn
without first draining or allowing contents to cool.
1. Verify the urn is clean and properly
sanitized.
2. Be sure the faucet is placed in the “OFF”
position.
3. Carefully fill the urn. Do not overfill.
Maximum fill is to the indented line near
the top (approx. 1 inch below the top).
4. Place lid onto top of urn.
Cleaning & Maintenance
CAUTION:
Burn hazard. Water used for brewing
tea is very hot. Use caution when brewing, pouring, or
transporting hot tea. Never attempt to move the urn
without first draining or allowing contents to cool.
NOTICE:
Never use chlorine based cleaners such as
bleach to clean stainless steel. Do not use scouring
cleaners on the urn’s surfaces.
Disassembly
1. Empty the entire contents of the iced tea
urn.
2. For Crathco valve types (Model GTD3-C),
pull out valve and then remove handle.
3. For valve types with pinch tubes, open the
dispense valve by moving the dispense
lever to the fully open and locked position.
4. For valve types except Crathco:
a. Detach faucet retaining nut from
faucet by turning the nut
counterclockwise.
b. Remove faucet from tube by pulling
away from valve seat.
c. Disassemble faucet by turning the
handle locking nut counterclockwise.
5. For valve types with pinch tubes, reach
inside the urn and remove dispense tube by
grasping the dispense tube handle and
pulling outwards.
Stainless Steel Iced Tea Urns
Grindmaster
®
3
Burn hazard. Water used for brewing tea is very hot. Use caution when brewing, pouring, or transporting hot
tea. Never attempt to move the urn without first draining or allowing contents to cool.
Clean and sanitize your iced tea urn daily.
Do not keep brewed tea or other brewed beverages overnight.
CAUTION
Safety Information (continued)
