9
Heated Seats (if equipped)
On equipped vehicles, the lower and
back cushions of the driver and front
passenger seats can be heated.
The controls are located on the outboard
sides of the front seats. (The ignition
must be on for this feature to work.)
Activate the heated seats
• Press the lower part of the switch to
turn the heater to the LO setting.
• Press the upper part to turn the
heater on HI.
• Place the switch in the center position
to turn the heater off.
See Section 1 of your Owner Manual.
Note:
In order for the passenger heated
seat to operate, the passenger safety
belt must be buckled.
Raise or lower the seat
• Lift or depress the entire control.
Move the reclining front seatback
forward or rearward
• Move the recliner control (C previous
page) forward or rearward.
See Section 1 of your Owner Manual.
Manual/Power Lumbar
(if equipped)
The manual lumbar control knob is
located on the outboard side of the driv-
er’s seat. Turn the knob counterclock-
wise to increase lumbar support and
clockwise to decrease lumbar support.
The power lumbar control switches for
the driver and passenger seats are
located on the outboard side of the
seats.
See Section 1 of your Owner Manual.
Preventing Window Fogging
To clear fog or frost from the windshield
or side windows, turn the airflow control
knob to one of the following modes:
(Floor/Defog):
Use to clear the
windows of moisture and to warm pas-
sengers. This mode splits the air
delivery between the windshield and the
floor outlets.
(Defrost):
Use to remove fog or
frost from the windshield more quickly.
This mode directs most of the air to
the windshield.
When you select the floor/defog or
defrost mode, the system automatically
turns off the recirculation mode and runs
the air-conditioning compressor. The
recirculation mode cannot be selected
because outside air is needed to remove
interior moisture from the vehicle.
See Section 2 of your Owner Manual.
Canyon 07 A 4/26/06 9:02 AM Page 9