The Gluefast Company, Inc.
3535 Route 66, Building #1, Neptune, NJ 07753 USA
Telephone 732-918-4600 / FAX 732-918-4646 / E-mail:
LABEL PRO 5.5E LABEL GLUER INSTRUCTIONS
(MOTORIZED)
CAUTION: READ THESE INSTRUCTIONS BEFORE UNPACKING!
UNPACKING
1. Carefully unwrap two gold colored rollers packed in the folded section of the carton
insert. Be careful not to scratch or dent.
2. Remove gluer from carton. Place on table with rubber feed roller nearest you.
3. Remove upper portion of gluer.
4. Install grooved roller in lower bearing notches in the movable spring controlled arms
at each side of the tank. The grooved roller fits in with its’ attached gear to the left
side. (Model 5.5E-FG has two smooth rollers. The bottom roller has only one gear.)
5. Install the smooth applicator roller (with two gears) in the upper bearing blocks
(hook-like in shape). The gear attached directly to the roller should be on the left
side and mesh with the gear of the bottom roller. The top roller snaps into position
against the spring pressure of the lower roller.
OPERATION
1. Fill the glue tank with a water based glue/adhesive to the edge of the pour-out
trough. See “Fill to Here” lettered on the trough.
2. Place the upper portion of the gluer on the base. When done correctly you should
see the smooth roller through the opening in the upper portion.
3. Stripper fingers should be positioned on the smooth roller.
4. Plug power supply into wall outlet.
5. Turn gluer on by flipping the switch on the far right hand corner of the gluer. A red
LED should light up.
6. Insert the label underneath the white nylon rod above the rubber roller and feed the
label in a downward motion. A switch will be tripped which turns on the motor pulling
the label through the gluer and presenting the glued label to the operator. The motor
will automatically shut off.
7. IMPORTANT: If the unit is not used for more than half and hour it may be necessary
to rotate the black feed roller by hand to free up the glue rollers necessary to rotate
the black feed roller by hand to free up the glue rollers from any dried glue. Simply
place tips of fingers on top of the roller and push away from you. A quarter turn
should be adequate. The motor will now be able to turn the glue rollers.
