Safety 1
0020289288_02 MicraCom Installation and maintenance instructions
5
▶
Only solder connectors if the connectors
are not yet screwed to the service valves.
1.3.8 Heating water
Both unsuitable heating water and air in the
heating water may cause material damage to
the product and in the heat generator circuit.
▶
Check the quality of the heating water.
(
▶
If you use non-diffusion-tight plastic pipes
in the heating installation, ensure that no
air gets into the heat generator circuit.
1.3.9 Neutralisation device
To prevent contamination of the waste water:
▶
Check whether a neutralising unit must
be installed in accordance with national
regulations.
▶
Observe local regulations on neutralising
condensate.
1.3.10 Frost
To prevent material damage:
▶
Do not install the product in rooms prone
to frost.
1.3.11 Safety devices
▶
Install the necessary safety devices in the
installation.
1.4
Regulations (directives, laws,
standards)
▶
Observe the national regulations, stand-
ards, directives, ordinances and laws.
1.5
List of relevant standards for Great
Britain and Ireland
▶
You can find a list of relevant standards at
https://www.glow-worm.co.uk/standards.