Globalcom Engineering
This document contains the proprietary information of Globalcom Engineering. Its receipt or possession does not convey any rights to
reproduce or disclose its contents or to manufacture, use or sell anything it may describe. Reproduction, disclosure or use without specific
written authorization of Globalcom Engineering is strictly forbidden. Mod.N:Q060R06
3
/
26
3
SAFETY INFORMATIONS AND INSTRUCTIONS
BV1000GTV is conform to the standard EN 62368-1+AC+A11 Electrical Safety of Data Processing Equipment
including Electrical Office Equipment.
3.1
GENERAL SAFETY INFORMATION
BV1000GTV has been designed and manufactured to meet international safety standard but, like any
electrical apparatus, due care must still be taken.
Read and understand the instructions before using the equipment
Not remove any screws to enter into area for non-operators
Not allow liquid to spill into the internal cabinet side
Not allow anything to rest on the power cord or telecomm cords and ensure a properly routing of
all the cable to prevent damage or accidental contact
Not continue to operate with the equipment if you are in doubt about its normal working or if the
equipment has been damaged.
3.2
BASIC RULES
1)
The responsibility of the safety for the sockets in the power circuits is of the customer
2)
Verify that the power supply cable and the sockets are in good conditions
3)
Don’t work in dangerous conditions when alone
4)
If possible, connect and disconnect the signal cable at power off to avoid risk of shock caused by
possible contact of two equipment at different electrical potential.
5)
The client must install a lighting protection if the zone is subject to thunderstorm or overvoltage.
3.3
SAFETY COMPLIANCE
In order to fulfill the safety standard EN 62368-1, BV1000GTV must be powered by a PS2 Limited Power
Source.
