User's manual
Manual del usuario
Manuel de l'utilisateur
Customer Service
US: 1-800-645-2986
Servicio de atención al Cliente
US: 1-800-645-2986
Service à la clientèle
Canada: 888-645-2986
MODEL #
1
1. Sleeve leg Extender into leg at desired
Height and place bolt assembly as
shown and tighten.
2. Screw nylon glide into leg extenders.
3. Assemble front and back rail using stud
plates and lock nuts provided. The 2 x 2
x 1 channel is for the front of the unit
and the 1 x 8 channel is for the rear then
attach the 1/4" - 20 x 3/4" hex head bolt
and flat washer to the bottom most hole
in the back rail. (before tightening nuts,
make sure that the front rail and the
back rail are pushed inward
approximately 1/8" to allow the
worksurface to be mounted properly),
Note: Holes in rails should be facing up.
4. Place worksurface bottom up on a
protected surface (to protect laminate
from scratches). Place assembled frame
on backside of top, locate flush with
back edge of leg. (seam of edging to
back). Pre-drill holes 1/2" deep and
screw #12 x 3/4" screws in to secure
frame to top.
5. Set bench upright and adjust nylon.
Bench-In-A-Box
Technical
Workbench
B2334698: 72"W x 30"D ESD Laminate Top (ref page 3)
B2334699: 72"W x 30"D Plastic Laminate Top
B2334700: 60"W x 30"D ESD Laminate Top (ref page 3)
B2334701: 60"W x 30"D Plastic Laminate
Top
Summary of Contents for Bench-In-A-Box B2334698
Page 7: ...7 Technical Workbench...
