102 - 122
2.6
.
0
- VERTICAL POSITIONING
1 / 1
from
2000
to
••••
WORKSHOP MANUAL
page
2.6 VERTICAL POSITIONING
WARNING! Two people will be needed for this
operation. When lifting and tipping backwards,
only solid parts should be gripped (steering
wheel, frame, rear plate, etc.) and NEVER parts
of the bodywork in plastic.
The fuel tank must be checked before putting the
machine in a vertical position to make sure that there
is no more than 2 litres of fuel inside.
To assure full stability, the machine must only be rest-
ed on the points shown, inserting a block
(1)
of about
40 mm under the lower edge of the plate and taking
care not to damage the grass-catcher mounts
(2)
.
WARNING! Make sure that the machine is com-
pletely stable before carrying out any work, and
avoid doing anything that could cause it to fall.
3/2002
1
40 mm
2
<= ... RET ... <=
