N...92
WORKSHOP MANUAL
DRIVE BELT ADJUSTMENT
4.3
0
1 / 1
page
from
2007
to
••••
© by GLOBAL GARDEN PRODUCTS
4.3 DRIVE BELT ADJUSTMENT
If it seems that the forward drive is not working
properly after a long period of use or after replac-
ing the belt, this may be caused by a change in the
length of the belt.
– A loose belt reduces output from the transmis-
sion and limits forward movement power;
– a belt which is too tight increases noise and
results in jerky movements or tipping up when
engaging the drive.
In these cases the stretcher will need to be adjust-
ed.
The tension regulator can be accessed by removing
the inspection hatch.
Adjust the tension of the spring
(1)
by suitable
working on the nuts
(2)
until a measure of 119 ÷ 121
mm is obtained, measured on the outside of the
turns, with the transmission controls in neutral.
Lock the nuts
(2)
when the adjustment has been
made.
4/2007
1
119 - 121 mm
2
<= ...BACK... <=
Summary of Contents for N 92 Hydro Series
Page 1: ......
