1 / 1
6.1.
0
REPLACEMENT
OF TYRES AND WHEELS
General informations
The tyres used are of the “Tubeless” type and so
every repair of a hole in the tyre must be done by
a tyre specialist according to the methods used for
this type of tyre.
Related topics
Aligning the cutting deck
Tyre pressures
Front ....................... (Tyres 11 x 4.00-4) 1,5 Bar
....................... (Tyres 13 x 5.00-6) 1,5 Bar
Rear ....................... (Tyres 13 x 5.00-6) 1,5 Bar
....................... (Tyres 15 x 5.50-6) 1,0 Bar
A) Tyres
After replacing one or more tyres or the wheels, it is
al ways necessary to check the pressure and to check
the alignment of the cutting deck.
Replace distorted wheel rims as they could impair the
tyre’s hold.
B) Wheels
The wheels are held by a snap ring (1) which can be
removed with the help of a screwdriver.
NOTE
If a wheel is jammed onto the shaft, use a releasing
spray directing around the splining hole.
On assembly it is advisable to spread grease on the
shaft to facilitate the next wheel removal.
For the front wheels:
replace the shoulder washer (2)
and the flexible ring (1) with the bevel facing inwards.
For the rear wheels:
replace the shoulder washer (2)
and the flexible ring (1) with the bevel facing inwards
and check the axial gap of the wheel on the shaft; if it is
greater than 3 mm, a spacer (3) must be fitted between
the wheel hub and the shoulder washer (2).
MODEL YEAR 2015
MJ66-Hy
MJ66
WORKSHOP MANUAL
BACK
