5.3 REMOVAL OF THE WHEELS COVER
Removing the wheels cover may be necessary for:
– improving access around the engine,
– removing the rear plate.
Replace the accelerator from the wheel cover
side [see 6.7].
Release the seat safety cable (if installed) from
the wheel cover side [see 6.11].
Unscrew the lever knob (2).
Remove the cover caps (3a) and unscrew the two
nuts (4a) to disassemble the seat.
Release the spring (5) of the fixed cover of the
grass- catcher (6), by undoing the screws (7) which
hold on the small plate (8).
Undo the two self-threading screws (9) and loosen
the two screws (10) with nuts that hold the cover on -
to the rear plate.
Lift the wheels cover [see 2.5].
Undo the six screws which attach the tubular ele-
ment. Two of them are short (11) and four are longer
(12) and they can be reached from below.
When reassembling, do not forget to reattach the
con nector of the seat microswitch and to make sure
it works.
Close up the wheels cover [see 2.5].
Tightening torques
9-11-12
Self-threading screws for wheels cover ....... 6,5 Nm
10
M6 screws for wheels cover ............................ 8 ÷ 10 Nm
3/2015
72FL hydro
5.3
.
0
REMOVAL OF THE WHEELS COVER
1 / 1
쑮
쑮
쑱
쑱
WORKSHOP MANUAL
pag.
MODEL YEAR 2016
© by GLOBAL GARDEN PRODUCTS
11
12
6
7
8
5
9
10
6
3
4
2
<= ...BACK... <=
