ATTENTION:
-
All settings parameters must be assigned correct values. The Client ID param, that will be requested at the
website, is indicated on the configuration page when set in Configuration AP Mode.
NOTE
: The Client ID is the MAC ADDRESS inverted
Factory reset and Wi-Fi configurations reset
At any time you can delete/correct any settings, the procedure is as follow:
1)
Power the interface using the dedicated communication channel.
2)
Wait for the two LEDs (red and yellow) to light up, press and hold the "Restart" button for a period of 2
seconds until the yellow LED turns OFF, stop pressing the button at this point.
3)
The red LED will stay ON permanently for 5 seconds and the interface will now restart in access point mode
with all the settings erased.
Connecting with Ethernet cable (RJ45)
1)
The settings procedure should be always programmed via Wi-Fi, as previously described. Only connect the
interface cable after power is OFF.
2)
Turn interface power ON (using panel).
3)
Wait for both LEDs to start blinking. When the two LEDs flash alternately the interface is communicating with
the server.
ATTENTION:
-
DURING FIRMWARE UPDATE PROCEDURE THE ETHERNET CABLE SHOULD NOT BE CONNECTED.
-
The connection to the internal network should allow the interface to be connected by DHCP with access to
the exterior. If this is not possible the interface cannot communicate with the internet broker (external
server).
INT-TCP/IP-WEB / CONFIGURATION MANUAL / © GFE 210622
8
