Global American 3307880, User Manual

Page: 76 / 107

3307880 PCI CPU Card
Step 2: Attach the appropriate connector on the other end of the cable to the floppy drive.
Only one connector in the set can be used. Step 0:
4.4.2.3 Parallel Port Connector (CN9)
The onboard parallel port connector (CN9) connects to a printer. The 3307880 comes with
a multi-mode (ECP/EPP/SPP) parallel port. The parallel port interface features a 26-pin
flat-cable connector that requires an adapter cable if a traditional DB-25 connector is used.
The parallel port interface can be re-assigned to LPT2 or LPT3 through the BIOS
configuration utility. The default interrupt channel is IRQ7. Select ECP or EPP DMA mode
using the BIOS configuration utility.
4.4.2.4 Audio Interface (CN7)
AC’97 Audio signals are interfaced through a 10-pin flat-cable connector. The signals
include microphone line-in, line-in stereo and line-out stereo. An audio
10-pin-to-phone-jack adapter kit is required.
4.4.2.5 COM Port Connectors (CN4)
The 3307880 provides one internal RS-232/422/485 serial port interfaced through one
14-pin male header. The serial port facilitates the connection to serial devices or a
communications network, e.g., terminal console.
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of
two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
Jumper
76