Global American 3307880, User Manual

Page: 75 / 107

3307880 PCI CPU Card
Step 1: Find the ATA 66/100 flat cable in the kit that came with the CPU card.
Step 2: Connect one end of the cable to the CN11 connector on the CPU card. A keyed
pin on the IDE connectors prevents it from being connected incorrectly.
Step 3: Locate the red wire on the other side of the cable that corresponds to the pin 1
connector.
Step 4: Connect the other side of the cable to the HDD making sure that the pin 1 cable
corresponds to pin 1 on the connector. Step 0:
NOTE:
When two EIDE disk drives are connected together, back-end jumpers on
the drives must be used to configure one drive as a master and the other as
a slave.
Figure 4-2: Connection of IDE Connector
4.4.2.2 Floppy Drive Connector (CN14)
The floppy drive connector provides access to one (1) externally mounted floppy drive.
A 26-pin FPC connector cable is required for the connection to the floppy drive. The cable
should come with a 26-pin FPC-cable connector and floppy disk drive connector on the
other end. Follow the instructions below to connect an IDE HDD to the CPU card.
Step 1: Plug the 26-pin FPC-cable connector into CN14. Make sure that the red wire
corresponds to pin one on the connector.
75