Page
13
of
15
INTERNAL SIDETONE ADJUST
There is an internal trimmer pot for adjusting the level of the microphone that is sent
to the local headphone output (sidetone).
To access the trimmer pot the lid of the unit must be removed.
Equipment needed
1x M3 screwdriver
Please ensure that the unit is powered off and disconnected from mains before
starting this procedure
Procedure
To disassemble the GS-FW0035, remove screws 1, 2, 3 and 4 from the left-hand
side panel of the unit, and then the equivalent screw 3 on the opposite right side
panel of the unit.
Remove the left side panel.
The front panel can now be removed by sliding it towards the left of the unit, whilst
prying it backwards and away from the top and bottom ridges.
Take care when removing the front panel as not to tear or damage the ribbon
cables that connect the front panel board to the motherboard.
The front panel can be placed down resting forwards, so there is no need to
disconnect any cables.
You may now access the trimmer pot shown in the 2 pictures below.
1
2
3
4
Summary of Contents for GS-FW035
Page 11: ...Page 11 of 15 SIMPLIFIED BLOCK DIAGRAM...
Page 14: ...Page 14 of 15...
