Page
14
of
24
Running Dante Controller
At the time of writing this manual the Dante Controller looks as per the screenshot
below:
The Express
IP
MKII will have been named at the factory during test to allow them to
be identified by the Dante controller.
The format used for the factory name is:
‘Express-9040db- serial-100’
Where ‘Express-9040db’ refers to the Glensound product and MAC address and
‘serial-100’ refers to the its serial number.
Dante Controller TIP
If you have never run Dante controller before then make sure that on the bottom left
of the Dante controllers’ screen ‘P’ or ‘S’ is next to a green square as this indicates
that it is connected to a network. By clicking ‘P’ or ‘S’ a pop up box opens to allow
you to set what network interface the controller is using.
