Running Dante Controller
At the time of writing this manual the Dante Controller looks as per the screenshot below:
The Beatrice LUCIA will have been named at the factory during test to allow them to be
identified by the Dante controller.
The format used for the factory name is:
‘GLENSOUND-BEATRICE-LUCIA-SN-XXXX’
Where ‘BEATRICE-LUCIA’ refers to the Glensound product i.e. Beatrice LUCIA.
The ‘SN-XXXX’ refers to the serial number of the Beatrice LUCIA which can be found
printed on the rear or side of the unit.
The unit may be renamed in Dante controller by opening the ‘Device view’ window and
selecting Beatrice LUCIA in the drop-down menu. Go to the ‘Device Config’ tab and
change the name with the Rename Device box.
Note if you upload a new DNT file or clear the devices config then the name will change to
‘BEA-B4pl-xxXxXx’ whereby the ‘X’s refer to the devices MAC address.
