GRAPHIC HOLDER ASSEMBLY INSTRUCTIONS
IMPORTANT NOTE:- ENSURE ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO OPERATION
NEXUS
®
13G
C
1.
Integral Post Mounted Graphic Holder
1.1
Fasten the 'P' clips (Part C) to the back of the unit ensuring the 'P'
section is facing the outside edges of the unit. The clip is fastened through
the location holes under the upper lip on the unit with the nylon washer
(Part B) on the outer surface. The metal nut (Part E) is located in the inner
surface and can be tightened using the wrench (Part G) provided.
1.2
Lay the unit on its front and pass each tube through a 'P' clip. Ensure
the slotted section of the tube is at the top of the unit and that the slots
face inwards.
1.5
The graphic holder comprises of
a clear rigid wallet, a gray card infill
and optional graphics. Place the
chosen graphic in front of the gray
infill. (a second graphic can be
placed behind the gray infill so it can
be visible from the rear of the unit).
1.3
Pass the remaining screws through each of the locating
holes near the base of each tube (diagram B). The remaining
nuts can be loosely placed in position.
1.4
Push the tubes upwards until they
reach the base of the unit and the
screws are held in the locating slots at
the base of the unit. Tighten the fixing
screw and nut using the wrench and
allen key provided (diagram C).
1.6
Slide the assembled wallet down
in between the tubes until the hooks
on the edge of the wallet locate at the
base of each tube slot (diagram D).
1.7
Place the two caps in position on
top of each tube (diagram E).
D
E
B
Also included, clear rigid wallet, gray card infill, 2 x PVC tubes, 10 x recycling graphics.
A
Fixings Included
4 off
2 off
2 off
1 off
4 off
2 off
1 off
A
B
C
D
E
F
G
1. Wall Mounting Graphic Holder