HOMEDEPOT.COM/GLACIERBAY
Please contact 1-888-774-8062 for further assistance.
Installation
1
PREPARING FOR INSTALLATION
NOTE:
Before installation, make
sure all parts are present. Compare
parts with the Hardware Included list.
If any part is missing or damaged, do
not attempt to install the product.
□
Determine the desired mounting location,
and mark the wall where the unit will be
installed.
NOTE:
For secure installation, the
unit must be mounted to at least one
wall stud.
2
CUTTING THE OPENING FOR
PLUMBING FIXTURES
NOTE:
This step applies to vanity
cabinets with full back panels only.
□
Locate and mark plumbing on the back panel.
□
Drill a pilot hole through the back panel.
□
Use a keyhole saw to cut an opening for the
plumbing fixtures.
3
POSITIONING THE
CABINET
□
Move the cabinet into
place, and use wood
shims to level the
cabinet against the wall.
Use and Care Guide
Vanity Combo
HARDWARE INCLUDED
4
INSTALLING THE CABINET
□
For wall stud installation, insert #12 x 3 in. screws with
washers into the stud locations (not included).
□
For drywall installation, drill holes at the appropriate
locations and insert toggle bolts with washers (not included).
□
For concrete wall installation, drill 1/4 in. holes at the
appropriate locations and insert #12 wall anchors, followed
by #12 x 3 in. screws (not included).
Item #
1002 844 075
Item #
1002 835 359
Item #
1002 814 828
Model #
KHWHT48D
Model #
KHDOV48D
Model # KHDCOG48DY
5
INSTALLING THE HARDWARE
AA
CC
DD
BB
BB
KHG48D
□
Attach the handles (AA) and the knobs (BB) to the door
the top drawer on the vanity with short screws (CC) and
to the two lower drawers on the vanity with long screws
(DD).
6
REMOVING THE DRAWER
Press
downward
Press
upward
□
Press release levers in opposite directions while pulling drawer out of the vanity.
TOOLS REQUIRED
Claw hammer Safety goggles
Phillips
Screwdriver
Caulk/sealant
Power drill Measuring tape Wall hardware Keyhole saw Level
AA - Handle
x 7
BB - Long
Screw
x 8
CC - Medium
Screw
x 2
DD - Short
Screw
x 4
