MAPS™ MGCP HD (PKS109)
Quick Install Guide
Page 3
•
On PC2, Click
Call Reception
icon
on both MG1, MG2 and observe the
RTP_Stats_Display.gls
script activated in the
Call Reception window.
•
On PC1, from
Emulator-> Load Generation
from main menu
•
By default,
MGCPCallControl-TGW.gls
script and
TGWProfie0*
profiles are loaded.
➢
Total calls to Generate by default is set to ‘*’, (indicates no limit)
➢
Maximum Active calls to 2000.
➢
Fixed statistical distribution pattern
•
Click
Start
button to initiate the bulk call generation.
•
On both the MG1 & MG2 MAPS™ MGCP instances, click
icon and open
Call Reception.
•
Observe that the calls are automatically received at the
Call Reception (MG1 & MG2)
window running the Rx script.
•
To verify results, invoke
Statistics
window from
Reports
menu, to view the number of calls passed/failed, which are also
plotted as pie-graph, Calls per sec graph, and Simultaneous calls per sec graph. Switch to Message Stats tab to view the
statistics of the messages sent/received related to MGCP protocol.
•
Observe the RTP packets received on each port of the GL’s HD card logged in the RTP Core console
Troubleshoot
•
“Security Error: Application is not licensed”,
if you see this error when you run MAPS™ MGCP it indicates a problem with
either your dongle or license file.
➢
First verify that the dongle is plugged in and the red light is on
➢
Go to
C:\Program Files\GL Communications Inc\GLDONGLE
➢
Run
appl_list.exe
. Verify that there is a line in the table reading
PKS124 MAPS™ MGCP
with the serial number
you noted above.
•
If the SIP/RTP Core console does not invoke with the MAPS™ TestBed start-up, check for the following:
➢
RTP Soft Core licenses may not be installed for the dongle used. Run
appl_list.exe
available in the
C:\Program
Files\GL Communications Inc\GLDONGLE
directory. Verify that there is a line in the table reading
PKS102
RTP Soft Core
with the serial number you noted above.
➢
Verify that the MGC IP Address and RTP IP Address in the testbed parameters are configured with the proper
system IP address.
•
Verify Physical Connection
➢
Check manually the LEDs on the HD card connected, if the GL’s HD Interface card is located at local system
➢
To verify from remote location, run
Monitoring.exe
utility, which displays the link status SFP Type connection and the
auto negotiated link speed.
➢
Important Column Description:
P - Port number
A - Adapter number
Type - Connection type
Link - Link speed (Down indicates cable is unplugged or SFP module is incompatible)
