Fitting, electrical connection and operation
Best. Nr. 1060 00
Page 5 of 136
2.2 Device components
(1): KNX/EIB bus connection
(2): Programming key and programming LED (red). The programming LED blinks slowly when the
safe-state mode is active.
(3): Screw terminals (L,N) for connection of mains voltage supply
(4): Screw terminals (da+, da-) for connection of DALI line
(5): 2-digit 7-segment display (red) for the display of the selected DALI group ("01"..."32" / blinking =
group disabled) in manual control mode or for the display of more information:
"
": Indicates DALI commissioning phase after an ETS programming operation or after mains
voltage return. The display duration depends on the number of connected DALI devices
(only briefly after mains voltage return).
"
": Display in an unprogrammed state during manual control.
"
": Display of a false connection to the DALI connection terminals (da+, da+). Mains voltage
connected. DALI Gateway does not operate. The Gateway is ready for operation only after
the error has been eliminated and after a new initialization (mains voltage return).
"
": Indicates the automatic device replacement (cf. Chapter "2.5 Operation").
"
": Indicates an error occurring during the automatic device replacement
(cf. Chapter "2.5 Operation").
The 7-segment display is switched off during bus mode.
(6): Keypad for manual operation with status LED
ALL OFF
ON/ OFF/
da+
da-
L
N
D A L I
(6)
(1)
(2)
(4)
(3)
(5)