Manually changing settings with IR remote control
If enabled, individual settings for function block 1 can be changed during operation using a
remote control.
Sensitivity:
o
Increase sensitivity: Press
´
button.
o
Decrease sensitivity: Press
²
button.
o
Recall set sensitivity again: Press
³
button.
i
The manual adjustment of sensitivity by the adjuster
Sens.
(6) is overwritten by the IR-
remote control and vice versa.
Brightness threshold:
o
Change brightness threshold: Depending on requirement, press
Ê
button,
Ë
button,
Ì
button or
Í
button.
o
Set current brightness as brightness threshold: Press
É
button.
Run-on-time: The preset run-on-time of 10 seconds can be extended individually.
o
Extend run-on-time: Depending on requirement, press
¼
button,
Ï
button,
Ð
button,
Ñ
button or
Ò
button. Other values can be set with the
Ó
/
Ô
buttons.
5 Information for electrically skilled persons
5.1 Fitting and electrical connection
Detection field and range
Figure 2: Sensor window and detection area
The device has a detection area of 360°. The diameter of the detection area depends on the
installation height and the direction of motions of persons in the detection area (Figure 3).
The detection area becomes larger the greater the installation height, while the detection
density and sensitivity are reduced at the same time. When used as a presence detector:
Installation height should not be more than 3.5 m, otherwise fine detection is not possible.
82585602
20.09.2012
4/10
KNX/EIB
Presence detector