24
Assigning door opener of a "side/back" door
The door opener connected to the switching actuator is pro-
grammed at the respective door station as follows:
1. Press the "System prog." button on the
control device
for
3 seconds to start programming mode (see Page 19).
2. Briefly press the "Function" button on the
switching actu-
ator
several times until the "Türöffner" LED flashes.
3. Press the "Progr." button on the
switching actuator
for 3
seconds until the yellow LED next to the "Progr." button
flashes.
4. Press any call button on the
door station
for 3 seconds
until you hear a short acknowledgement tone.
3
A long acknowledgement tone confirms successful
assignment.
In addition, the door opener connected to the switching
actuator is operated for the set time.
To assign additional door stations to the same door opener,
repeat Step 4 at the next door station.
5. Briefly press the "Progr." button at the
switching actuator
to exit door opener programming mode of the switching
actuator.
3
The LED of the "Progr." button goes out.
The LED of the last selected function ("Door opener" in this
example) continues to flash until programming mode at
the control device is exited.
6. Press the "Systemprogr." button on the
control device
to
exit the programming mode.
Releasing the button after 3 seconds
If the button press is not ended after the first acknowledge-
ment tone, all assignments of the respective door/home
station will be deleted after an additional 3 seconds.
Summary of Contents for 1288 00
Page 1: ...Operating Instructions System Manual Video Control Device 1288 00...
Page 2: ......
Page 14: ...14 adjustable activation time of door opener...
Page 43: ...43...