GIRA
Info
Multifunction Radio Transmitter
Installation Instructions
Multifunction Radio Transmitter
05/01
Page: 1 of 8
Flush-Mounted Four-Channel
Multifunction Radio Transmitter
Order No.: 0441 00
A
1x
CR2032
c
d
Function
This multifunction radio transmitter (Fig. A: Front view) is a
battery-operated four-channel radio transmitter for the
extension of an existing radio control installation.
At its four inputs E1 to E4 (see Fig. C), the multifunction
radio transmitter detects switching states of potential-free
installation switches or push-buttons.
It transmits radio data telegrams which can be decoded by
all radio control receivers.
A 5-digit microswitch (Fig. A
c
) facilitates the selection of
eight different modes of operation.
A red LED (Fig. A
d
) indicates the transmission of radio
telegrams (slow unsymmetrical blinking, 4 Hz) or an empty
battery "LowBatt" (quick symmetrical blinking, 10 Hz).
Safety instructions
Attention: Electrical equipment must be installed and fitted by qualified electricians only.
To avoid possible damage to the electronic circuitry by electrostatic discharge, observe the pre-
cautions for the handling of components sensitive to electrostatic discharge when changing the battery
or operating the microswitches.
B
c
d
Installation
Install the multifunction transmitter (Fig. B
c
) in a surface-
mounted or flush-mounted box behind a potential-free
installation switch or push-button (Fig. B
d
).
The multifunction transmitter has no pull-relief.
Important
To avoid saturation of the radio receivers (actuators), the
distance between the transmitter and the receiver must be
approximately 1 m.
Cable
The eight-wire cable serves to connect potential-free
installation switches and push-buttons.
Wires not used should be insulated and must
not
be brought
into contact with live parts to prevent the device from being
irreparably damaged.
