Giltrap WideTrac, Operations & Parts Manual

Page: 20 / 46

Page 20
WideTrac Operation & Parts Manual
LEDs and Warning Messages

“Slow Down” will be displayed when ground speed is too high. Tractor hydraulic
flow cannot drive conveyor fast enough to maintain set spread rate. Decrease
ground speed or decrease set spread rate. Normally only shows when the
controller is set to very high spread rates and door is already opened to maximum
height.

“Increase Speed” will be displayed when the ground speed is too low. The
conveyor cannot be run slow enough to spread required rate at measured ground
speed. Increase ground speed or increase set spread rate. Normally only shows
when the controller is set to very low spread rates.

“Door Opening” will be displayed when the door is moving to the start-up position

“Door Closing” will be displayed when door is closing. When powering off.

“RED” LED on when the door is opening to start-up position (not ready to spread)

“GREEN” LED on when machine is spreading normally or is ready to spread.

“BLUE” LED on when door is closing

“YELLOW” LED on when machine is travelling outside “Ideal Speed’ range

“IDEAL SPEED ERROR” shown when ideal speed setting is not possible. Adjust
setting down or turn off.

“ACTUATOR ERROR” shown when there is a power or control fault in the door
actuator