Gilson F81013, User Manual

Page: 5 / 54

PA
R
T
S CH
E
CK
LIS
T A
N
D
A
C
CE
S
SO
R
IE
S
5
PIPETMAN® M
|
USER’S GUIDE
Chapter 2
PARTS CHECKLIST AND ACCESSORIES
Parts Checklist
Take a moment to verify that the following items are in the box:
●
PIPETMAN M pipette
● Power Supply 5V with AC adapter and cable
● 4 Battery side tags
●
4 Ejector side tags
●
Tip ejector extension (P10M model only)
● Quick Guide
Accessories
ACCESSORIES PART NUMBER
POWER CARROUSEL: 5–position charging carrousel for single and
multichannel models FB1001
Battery side tags (set of 4) F807013
Ejector side tags (set of 4) F807014
Chapter 3
GETTING STARTED
Please contact your Gilson representative to order additionnal accessories.
NOTE
PIPETMAN M is provided with a minimal battery charge. Before using your
new PIPETMAN M, we strongly recommend that you to fully charge the
battery. PIPETMAN M charges 80% of its full battery capacity in less than an
hour, it takes three hours to fully charge the battery. Please refer to
Chapter 12
Power Management
on page 18 for charging procedure.
Switch on your PIPETMAN M. Press the push button to activate
the pipette. The start-up screen appears:
The pipette will do a self calibration test and the firmware
will reset the piston.
During initialization, the volume range, version of the
firmware, and the number of readjustments is displayed on
the screen (refer to Standard Readjustment on page 22).
Your PIPETMAN M is preset to PIPET mode
and is now ready to pipette (Refer to Chapter 5
Pipetting Just Like with PIPETMAN on page 7).
PIPETMAN M goes into sleep mode (display turns off) after three minutes of inactivity.
Press the push button to reactivate the pipette. Your last setting and pipetting mode
will appear on the screen.
●
Safety bag
● Certificate of conformity
(including bar-code sticker)
● Lubricant (except for P10M,
and the multichannel models)
Volume
range
Version of
firmware
Number of
readjustments