GILLIG LOW FLOOR, Service Manual

Page: 380 / 506

Electrical System
380
Figure 9-20, Starter Installation
FROM BATTERY
FROM
STARTER
SWITCH
BOLT
55 ft-lb, 75 Nm
TORQUE
GROUNDED TO FRAME
10-32 GROUND STUD
1.3 - 2.5 ft-lb
1.8 - 3.4 Nm
TORQUE
MOTOR TERMINAL
1/2-13
1.3 - 2.5 ft-lb
1.8 - 3.4 Nm
TORQUE
Starter Installation
1. Use a suitable strap to raise the starter into position against the engine block.
2. Secure the starter to the engine block with three bolts (Figure 9- 20). Tighten the bolts to 55 ft-lb
(75 N-m) torque.
3. Connect the 24 volt cable to the starter solenoid and connect the ground cable to the starter
grounding stud. Tighten the locknuts to 25 ft-lb (35 N-m) torque.