GILES GBF-70, Operation & Service Manual

Page: 25 / 108

13
Installation
GBF-70 Fryer
5. If the unit is equipped with the optional on ‐ board Oil Top ‐ Off
system (not bulk fresh oil) , press and momentarily hold the
OIL FILL PUSHBUTTON ④ on the control panel. You
should hear the top ‐ off pump start to run. Release the
button and the pump should stop.
If either pump does not run or suction is not detected
at the filter pan coupling
② , refer to Section 6.02,
Troubleshooting Procedures , else proceed to next
section.
2.09.3 Filter Pump Test
1. Open cabinet door (unit with filter pan on banked system) . If
needed, disconnect and remove the filter pan from the unit.
2. Place the Oil Return valve ① in the [FILL POT] position
(horizontal).
3. Firmly press the palm of the hand over the Filter Pan Coupling
② on the front brace.
4. While covering the opening with the hand, place the
Pump Switch
③ in the [PUMP] position. The filter pump will start ... if suction
is felt, it is operating correctly. Return switch to [OFF]. Allow
pump to ONLY run long enough to check for suction.
The following test confirms that the filter system pump is operating properly.
2
1
3
IMPORTANT!
Before using the appliance for the first time, it is necessary to perform a Boil ‐ Out Procedure (for all units of a banked
system). This process will remove residue which may remain from manufacturing processes, or dirt and debris that may
have accumulated during warehousing and shipment. For details concerning the
Boil ‐ Out Procedure see Section 5.01 .
2.09.4 Initial Boil-Out Procedure
OIL TOP ‐ OFF PUMP (if equipped):
4