Gilera Nordwest, Workshop Manual

Page: 86 / 136

In order to avoid any abnormal leakages, it is suitable to don’t carry out
the thin plates locking too strong.
Installation (fig.36)
Insert the rod “N” together with the thin plates into the hydraulic cartridge “O”.
Fit on the rod the lower plug “Q” together with the relevant bushing, then install
the lock ring.
Tighten the plug “P” into the plug “Q”, the inner bushing must slide freely.
Tighten the plug “R”, paying attention to align the spring pin hole with the
hydraulic cartridge hole “Z”.
Insert a new spring ring, sticking out about 3 ÷ 4 mm.
Insert the complete hydraulic cartridge, then, by means of the appropriate tool,
screw the plug “M”.
Carry out the same operations on reverse order of disassembly.
13 - 4,2