Gilderfluke & Co Br-EFB, Manual

Page: 137 / 142

F) Loop Commands:
“!” (card address) ! ! ! ! ! ! ! Loop Track:
! “ “ ” !! ! ! ! ! ! ! ! ! ! ! Loop Global:
Instead of using the ‘start’ commands, the ‘loop’ commands are
generally a better choice. The difference between the ‘start’ and ‘loop’
commands are that at the end of a show which is started with a ‘loop’, it
will check to see if any actions were set for the end of the show. A show
that is started with the ‘start’ command will play to the end and then just
stop and wait for the next command.
These command acts much like the START commands, except that
they also set the ‘LOOPING SHOWS’ flag. With the this flag set, it is
possible to set a sequence of shows playing in any order. Since the ‘next’
show can be any show you ask for, one show can be played over and over
again, or you can set up a sequence of shows which will be repeated until
the Br-EFB is told to stop.
G) Stop at End Commands:
“%” (card address) ! ! ! ! ! ! Stop at End Track:
! “&” ! ! ! ! ! ! ! ! ! ! ! ! Stop at End Global:
These commands reset the ‘LOOPING SHOWS’ flag in the selected
Br-EFB(s). What this does is to stop them playing when the end of the
current show is reached. These commands are used when you want the
shows to finish gracefully, instead of stopping in the middle. The STOP
commands are used when you want to stop a show immediately.
H) Select Show Commands:
“)” (card address) (show#) !! ! Select Show Track:
! “*” (show#) ! ! ! ! ! ! ! ! Select Show Global:
Up to two hundred fifty-five different animated shows can be stored on a
single Br-EFB. These commands can be used to select an individual show
on the selected Br-EFB(s). Individual shows can be requested with a range
of 01 to FFH. Once a show is selected, it will be played on the next serial
port START or LOOP command.
If a show selection has been made inadvertently, it can be cleared by
sending a request for show number 00.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Br-EFB Manual / May 22, 2018 3:28 PM / page 137 of 142