FlexPay NC3L Wide Installation and maintenance
iv
WARNING
THE UNIT BEING THE SUBJECT-MATTER OF THIS MANUAL SHALL BE
INSTALLED AND COMMISSIONED BY TRAINED PERSONNEL
Trained personnel means people with the appropriate technical education and
experience required to:
- carry out operations in areas accessible by technical assistance staff,
- be aware of the dangers involved in carrying out the operations, and be instructed
about the measures required to minimise those dangers.
This equipment contains batteries and/or non-rechargeable batteries. This indicates
that these batteries shall be replaced and disposed only by trained personnel
certificated by Gilbarco.
Disposal of the equipment involves the battery removal in accordance with the
provisions laid following the instructions supplied by trained personnel certificated
by Gilbarco.
NOTE
Gilbarco declines all responsibility for any damages to property and/or persons due
to incorrect installation of equipment, incorrect connections or changes made to the
equipment, as well as for damages due to connections with other devices not
described in this manual.
DISCLAIMER
The equipment installed and put into service following the instructions given in this
manual, will operate fully covering the characteristics described here.
Installation and put into service of the equipment in different way from the
instructions given in this manual, but that have followed the local laws, rules and
requirements for installations in Petrol Service Stations and have followed the
provisions about the safety disconnection devices given at chapter “Electrical
Installation” are generally allowed, but the performance may be affected.
DANGER
Before performing any electrical operation make sure that all devices have been
disconnected from the mains power.
Before performing any electrical installing/uninstalling operations, make sure that
also supply lines are isolated from mains by safety disconnection devices.
WARNING
The equipment shall be installed into an electrical system complying with the plant
engineering regulations in force and equipped at least with a 2-pole, 6A, C curve,
MCB differential for each supply line.
The electrical cables used for connections shall comply with the plant engineering
regulations in force, depending on the installation conditions (e.g. indoor or outdoor
underground, in cable duct, etc.) and they shall meet any functional characteristics
prescribed by Gilbarco.
