Installing the HCRS Kit
Page 8
MDE-5387D Hybrid Card Reader S (HCRS) Kit Installation Instructions · May 2020
Installing the HCRS Kit
A properly grounded ESD wrist strap must be worn while servicing any electronic
devices or components. Failure to use electrostatic precautions may damage
electronic components and void warranty.
CAUTION
Removing the Existing Card Reader
To remove the existing card reader, proceed as follows:
Note: Read all instructions before beginning and observe all safety precautions.
1
Open the door.
Encore 500/500 S/700 S:
a
Remove the lower hydraulics panel to access the security latch underneath the lower left
main door corner; open the latch.
b
Locate the upper main door lock. Insert the main door key and open the door.
Other Encore models:
Insert the main door key and open the door.
The Advantage Series:
a
Open the left and right option doors using the key.
b
On side A, unlatch the door latches located behind the right and left option doors. Loosen the
four screws at the bottom of the main access door using a 5/32 or 3/8-inch Allen wrench.
c
On side A, open the main access door by lifting it slightly. Place the main access door hinge
bracket pin into the end slot/lock position. This locks into a maximum 90-degree angle.
2
Unplug the connector from the card reader only
. Do not remove the cable harness from the
dispenser.
