MDE-4699L Applause™ Media System Installation, Service, and Parts Manual · June 2017
Page D-3
Configuring Linksys® Router
Broadband Router and Network Configuration
4
Change the laptop static IP to
10.5.48.200
and the subnet mask to
255.255.255.0
.
5
Reconnect to the router at
10.5.48.1
.
6
Select
DHCP
.
7
Under
Dynamic IP
change the
Client Lease Time
to
43200
.
8
Change
Range Start
to
10.5.48.120
and the
Range End
to
10.5.48.140
.
9
Click
Save
to save the changes.
10
Open up an Internet browser window,
should be accessible. If not, contact
the site’s IT department or Internet service provider for additional settings.
Note: If using a customer supplied router with wireless capability, the wireless capability must
be disabled.
Configuring Linksys
®
Router
To configure the Linksys Router (Q13708-05B), proceed as follows:
1
Connect a laptop to one of the eight ethernet ports on the router using a non-crossover CAT-5
cable.
2
Set the laptop NIC TCP/IP settings to obtain an IP address automatically.
3
Click
Start
>
Run
.
4
Type
CMD
and click
OK
. The Command Prompt window appears.
5
Type
ipconfig
and click
Enter
. The current IP configuration of the laptop appears.
Figure D-3: Command Prompt Window
Note: After this router is preconfigured for the Passport system, the IP address must be set to
10.5.48.X.
