Giken GSK Series, Instruction Manual, Page: 78 / 109

77
１０．
Code table
１０－１
NG Code List
Operation
Code
display
Matter
Basic NG
FFFF
FF00
Emergency stop
Preparation for operation off during operation or START OFF in the
running program.
Before
starting
check,
etc.
0001
Zero offset error
During the zero / double check, zero point output has exceeded the
limit over range.
0002
Magnification error
During the zero / double check, magnification output exceeds the
limit over the range.
0003
Zero offset fluctuation error
Difference in the previous and current output value exceeds the set
over.
0004
Magnification fluctuation error
Difference in the previous and current output value exceeds the set
over.
0033
1.On nut runner
Tightening sampling error
2.On position mode
Return to origin point over time error
0034
Homing operation at the time of incomplete.
Position move command of the X/Y-axis has been issued in the state
of origin return is not yet completed.
SOC.T
0106
Gear checkNG1
In the torque-free monitoring time, angle tightening has reached the
cut angle.
0107
Gear checkNG2
Motor current during rotation exceeds the torque upper limit
equivalent.
※
The torque limit is a current value.
0108
Fitting angle over
It does not reach the fitting torque exceeds the cut angle.
0111
SOC.T torque over
Torque value at the time of arrest has exceeded the upper limit.
0112 SOC.T torque under
0133 SOC.T over time
PRE.T
0207
Pre tightening early tightening NG
It reaches the second speed switching torque between the closed
fast decision angle from the start.
0211
Pre tightening torque over
The torque value at the time of arrest has exceeded the upper limit.
0212
Pre tightening torque under
The torque value at the time of stopping does not reach the lower
limit.
0221
Pre tightening time over
The time when stopped exceeds the maximum.
0222
Pre tightening time under
It does not reach the lower limit time at stop.
0231
Pre tightening angle over
Angle at the time of arrest has exceeded the upper limit.
0232
Pre tightening angle under
Angle at the time of arrest does not reach the lower limit.
0233 Pre tightening over time
0240 Pre tightening area over