Giken GSK Series, Instruction Manual, Page: 74 / 109

73
７－１７
(Fn.7) ID controller connection setting
Number Matter
No.0 ID controller output content setting
No.1 ID controller output content setting
No.2 Function selection of the Interface unit CH12
No.3 SIO start address setting " set at the 1-7 "
No.- Save at once all of the data of Fn.12 at the SAVE button.
Please refer to the following about the details of the above-mentioned Fn.7.
No. Digit Setting value Transmission timing
No._0
1 st digit
0 Data transmission at block judgement output
1
Data transmission at start of next block and input of
judgement reset input
2 Data transmission from command from the upper device
Min.3 Not used
2
nd
digit 0 to 7 Set the digit no. of engine no. transmission (digit no-1)
3
rd
digit 0/1
Setting of with or w/o transmission eith axis no.
0: not to be transmitted
1: to be transmitted
4
th
digit 0/1
Setting yes or no with transmission of each axis judgement
0: not to be transmitted
1: to be transmitted
No._1
1
st
digit
Refer to the
undermentioned
data
Set the digit no. of transmission with torque
2
nd
digit Set the digit no. of transmission with time
3
rd
digit Set the digit no. of transmission with angle
4
th
digit Set the digit no. of transmission with gradient
No._2
1 st digit 0 to 4
I/F unit selection of ch2 function
0: Operation as printer port
1: Connection of ID controller of standard specification
2: Output of T spec. torque and judgement
3: Output of T spec. judgement
4: Connection with J spec. ID controller Quality control PC
This port is possible with operation
if the number is order than zero.
2
nd
digit 0/1
Set Yes or No with transmission of date and time
0: not to be transmitted
1: to be transmitted
3
rd
digit 0/1
Set Yes or No with transmission of program no.
0: not to be transmitted
1: to be transmitted
4
th
digit 0/1
Set Yes or No with transmission of unit no.
0: No/select gradient 1: Yes/select gradient
2: No/select snag. 3: Yes/select snag
No._3
―
1 to 7
Set address of M-Net station
Set station address of unit 1. Address after 2 is the serial
number following to setting value *1.
No._
－
Save the whole data of Fn.12 in a lump by the SAVE button