Giken GSK Series, Instruction Manual, Page: 47 / 109

46
５－１０
Operation preparation OFF and program start OFF in the program operation
（
At the 1 step × 2 blocks program , “Operation preparation OFF" occur in the first block and “program start off”
occur the 2nd block.
）
Control power supply
Drive power supply
Input signal
(PLC
→
GSS)
Operation ready
Automatic/inching
Program start
Inching start
Determination reset
Alarm reset
QL input
QL mode
IN wait input
Program selection
(1 to 5)
Input ENABLE
Reset
Tightening angle sampling
start
Block selection (1 to 5)
Output signal
(GSS
→
PLC)
Operation ready OK
Device OK
Battery OK
Total OK
Total NG
Operating
Executing
QL processing
end
Step completion
Program selection
output (1 to 5)
Output ENABLE
Block OK
Block NG
Block selection output
(1 to 5)
Blocks OK/NG (1 to 10)
Operations OK/NG
Axes OK/NG (1 to 30)
Cycle stop
0.2 sec. min.
1 block 1 block Quick stop (1 sec. max.) Quick stop (1 sec. max.)
1 block NG
Running operation
NG
All operating axes
NG
2 block NG
Running operation
NG
All operating axes
NG
(GSK → PLC)
(PLC → GSK)