Giken GSK Series, Instruction Manual, Page: 105 / 109

104
About connection setting of ID controller
１．
Outline
Connecting the interface unit with ID controller by serial communication (RS422), transfer of engine number,
setting of the calendar and transmission of result data become possible.
２．
Secification of communication
Communication method
：
RS422
Communication speed
：
9600bps
Start bit
：１
Stop bit
：１
Parity
：
non
Transmission start character
：
‘
＃
’
（２３Ｈ）
Transmission finish character
：ＣＲ（０ＤＨ）
Transmission character
：
ASCII code
３．
Ressive format
（ＩＤ
controller → Interface unit
）
Ressive of engine number.
＃［
Engine number
］ＣＲ
Engine number should be maximum 7 figures by decimal numeral.
Data transmit demand or Specify of unit to send the data.
＃Ｕ［ｎ］ＣＲ
Unit No. specified
（ｎ＝
1 to 6
）
Setting of callendar
＃Ｃ［
Callendar
］ＣＲ
Callendar setting
（
year, month, date, hour, minute each 2 figures
）
４
. Transmission format
（
Interface unit →
ＩＤ
controller
）
（１）
Standard specification setting
（
1 st figure = 1 of
ｆｎ
12 no.2
）
＃［
Date and time
］［
Judge
］［
Axis No.
］［
Program No.
］［
Unit No.
］［
Torque
］［
Time
］［
Angle
］［
Gradient
］［
Engine
No.
］
CR
［
Date and time
］＝０１／１２／２９
△
１５：５９ （１４
letters
）
△
means blank
（２０Ｈ）
［
Each axis judgement
］＝
0000
（ＯＫ）
or
ＮＧ
code
（４
letters
）
［
Axis no.
］＝
01 to 30
（
2 letters
）
［
Program no.
］＝
01 to 24
（
2 letters
）
［
Unit no.
］＝
1 to 6
（
1 letter
）
［
Torque
］＝
123.4
（
Number of letters is according to the parametter
）
［
Time
］＝
12.34
（
Number of letters is according to the parametter
）
［
Gradient
］＝
99.9
（
Number of letters is according to the parametter
）
［
Engine no.
］＝
1234567
（
Number of letters is according to the parametter
）