60
Using a handset as a room monitor
Gigaset SL400/400 A / IM-MEA EN / A31008-M2103-A601-2-UZ19 / registr_sett.fm / 10.11.2010
V
e
rsion 4, 16.0
9
.2005
Ending listening in
a
Press the end call key.
All participants hear a signal tone.
If the
first
internal participant presses the
end call key
a
, the handset that has "lis-
tened in" remains connected to the external
participant.
Changing the name of a
handset
The names "INT 1", "INT 2" etc. are assigned
automatically at registration. You can
change these names. The name must be no
more than 10 characters. The changed name
is displayed in every handset's list.
u
Open the list of handsets. Your
own handset is indicated by
f
.
s
Select handset.
§Options§
Open menu.
Rename
~
Enter name.
§Save§
Press the display key.
Changing a handset's
internal number
A handset is
automatically
assigned the
lowest free number when it is registered. If
all slots are occupied, number 6 is overwrit-
ten if this handset is in idle status. You can
change the internal number of all registered
handsets (1–6).
u
Open the list of handsets. Your
own handset is indicated by
f
.
§Options§
Open menu.
Assign Handset No.
Select and press
§OK§
.
r
Select number.
§Save§
Press the display key to save the
input. Only numbers that have
not yet been assigned can be
designated.
Using a handset as a
room monitor
If the room monitor is activated, a previously
saved destination number is called as soon
as a set noise level is reached. You can save
an internal or external number in your hand-
set as the destination number. All of the
handset keys are deactivated, with the
exception of the display keys.
The room monitor call to an external
number is terminated after approximately
90 seconds. The room monitor call to an
internal number (handset) stops after
approx. 3 minutes (depending on the base).
When the room monitor is activated, all keys
are locked except the end call key. The hand-
set's speaker is muted.
When the room monitor is activated, incom-
ing calls to the handset are indicated
with-
out a ringtone
and are only shown on the
screen. The display and keypad are not illu-
minated and advisory tones are also turned
off.
If you accept an incoming call, the room
monitor is suspended for the duration of the
call, but the function
remains
activated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.
Activating the room monitor and
entering the destination number
v
¢
É
¢
Room Monitor
¤
You can enter data in the following fields:
Activation:
Select
On
to activate.
Alarm to:
Select
Internal
or
External
.
External number:
Select the number
from the directory (press display key
ö
)
or enter it manually.
Internal number:
Select display key
§Change§
¢
Select handset or
Call All
to
call all registered handsets
¢
§OK§
.
