57
Using multiple handsets
Gigaset SL400/400 A / IM-MEA EN / A31008-M2103-A601-2-UZ19 / registr_sett.fm / 10.11.2010
V
e
rsion 4, 16.0
9
.2005
The wake-up call sounds for 60 seconds. If
no key is pressed, the wake-up call is
repeated twice at five minute intervals and
then switched off.
During a call, the wake-up call is only sig-
nalled by a short tone.
Deactivating the wake-up call/
repeating after a pause (snooze
mode)
Prerequisite
: A wake-up call is sounding.
§Off§
Press the display key. The wake-
up call is deactivated.
or
§Snooze§
Press the display key or any key.
°
is shown in the display... The
wake-up call is deactivated and
then repeated after 5 minutes.
After the second repetition the
wake-up call is deactivated
completely.
Using multiple handsets
Registering handsets
You can register up to six handsets to your
base.
A Gigaset handset can be registered on up to
four bases.
Manually registering
Gigaset handsets to the Gigaset
SL400/SL400A
You must manually register the handset on
both the handset (1) and the base (2).
Once the registration process has been com-
pleted successfully, the handset returns to
idle status. The handset's internal number is
shown in the display e.g.,
INT 1
. If not, repeat
the procedure.
Registering other handsets
You can register other Gigaset handsets and
handsets for other devices with GAP func-
tionality as follows.
1) On the handset
The handset is not registered to a base.
§Register§
Press the display key.
The handset is already registered to a base:
v
¢
Ï
¢
Registration
¢
Register Handset
If the handset is already registered to four
bases:
s
Select base, e.g.,
Base 3
and
press
§OK§
.
~
If required, enter the system
PIN for the base and press
§OK§
.
A message appears stating that the hand-
set is searching for a base that is ready for
registration.
2) On the base
¤
Within 60 seconds, press and
hold
the
registration/paging key on the base
(
page 2) (approx. 3 seconds).
1) On the handset
¤
Start to register the handset as
described in its user guide.
2) On the base
¤
Press and
hold
the registration/paging
key on the base (
page 2) (approx. 3
sec.).
