69
Making VoIP settings
Gigaset S450 IP LBA / IM-Nord_en / A31008-M1713-R221-1-7619 / settings_bs_hs_pabx.fm / 31.10.06
Ve
rs
ion 4,
16
.09.
2005
Automatic firmware update
Your phone will check daily whether a
newer firmware update is available via the
Internet on the Siemens configuration
server. If this is the case, the message
New firmware available
will be displayed
when the handset is in idle status, and the
message key
f
flashes.
f
Press the message key.
§Yes§
Press the display key to con-
firm the prompt.
The firmware will be loaded onto your
phone.
Making VoIP settings
In order to be able to use VoIP, you must
set a few parameters for your phone.
You can make the following settings using
your handset.
u
Download the general access data for
your VoIP provider from the Siemens
configuration server and store them on
your phone.
u
Enter your personal access data for
your first VoIP account (first VoIP phone
number). You can configure the access
data for three further VoIP account via
the phone's Web configurator.
u
Setting the phone's IP address in the
LAN.
The connection assistant on your phone
can help you make the settings.
Using the connection assistant
The connection assistant starts automati-
cally when you set the handset and base
station up for the first time, or when you
try to connect to the Internet before mak-
ing the necessary settings.
You can also start the connection assistant
via the menu:
v
¢
Ð
Settings
¢
Telephony
Connection Assist.
Select and press
§OK§
.
~
Enter the system PIN and press
§OK§
.
For how to enter VoIP settings using the
connection assistant, see page 12.
Notes:
– The firmware update can last up to 3 min-
utes.
– When updating from the Internet, checks
are made to ensure that no newer version
of the firmware exists. If this is not the case,
the operation is terminated and a message
is issued to that effect.
– If an error arises during a firmware update
from a local PC, the most recent version of
the firmware is automatically downloaded
from the Internet. Your phone should
therefore be connected to the Internet dur-
ing every firmware update.
Notes:
– If you reply to the request with
§No§
, the dis-
play will not be repeated. The message
New firmware available
will only be shown
again if a newer version of the firmware
than the one rejected is available.
– You can specify the automatic version
check via the Web configurator (page 93).
Note:
You can set these and other parameters
conveniently via the Web configurator on a
PC connected to your local network (see
