9
Gigaset L410 / en-USA / A31008-M2240-R301-2-UL19 / archimedes_en.fm / 14.03.2012
V
e
rsion
1, 1
4
.03.20
12
All participants hear a signal tone when a participant joins or leaves the
conference call.
Conference calls
A call is being held on the
handset
or on the
Gigaset
L410
. You would like to participate in the call with
(another) Gigaset L410.
¤
Hold down
the Answer/End call key on the Gigaset
L410 (until you hear a short signal tone).
A call is being held on the
Gigaset L410
. You would
like to participate in the call using the handset.
¤
Hold down
the Answer call key on the handset.
This applies to telephones that support the “Listening In” function. If necessary, switch
this function on.
Note
On telephones without the
“Listening In”
function
(e. g. ISDN or IP
telephones), or if the function is switched off:
Handset:
(is in an external
call)
¤
Call the Gigaset L410 on an internal line (with Gigaset
telephones, press the Int key to do so, where necessary,
select the Gigaset L410 from the list of handsets registered,
press Answer call key).
Gigaset L410:
¤
Accept the call.
Handset:
¤
Start the conference call as described in the operating
instructions for the handset.
Note
Acoustic feedback (whistling noise) may occur when you are phoning in the same
room with a Gigaset L410 and a handset in handsfree mode. In this case, end the
handsfree mode on the handset or increase the distance between the devices.
External
participant
or two Gigaset L410
