5
Preparing to use the handset
SL 74 / IM1 eng / A31008-L074-B002-1-6Z19 / start_guide_time.fm / 12.07.2004
Opening the battery cover.
1. Hold the handset with the keypad
facing down.
2. Place the thumb of the other hand on
the mirror near the loudspeaker (a) and
with the index finger of the same hand
press the grooved area on the
handset (b).
3. Lift the cover.
Charging the battery
1. Plug the charger's power supply unit
into a mains socket.
2. Place the handset in the charger with
the
display up
.
Now leave the handset in the charger for
the battery to charge. Battery charging is
indicated in the top right of the display by
changes in the level indicator on the
battery icon
=
.
First charging and discharging of
the battery:
The battery charging status is correctly
displayed only after uninterrupted
charging
and
discharging.
For the initial charge we recommend
leaving the handset in the charger
continuously
for
five
hours. Then remove
the handset from the charger and do not
recharge it until the battery is completely
flat.
After initial charging
and
discharging, you
can replace your handset in the charger
after each call.
Please note:
u
You must always repeat this procedure
when you remove the battery from the
handset and replace it again.
u
The battery heats up during charging.
This is normal and not dangerous.
u
After a while the charge capacity of the
battery will decrease for technical
reasons.
Registration
You have to
manually register
your SL 74
before you can use it. It can be registered
on up to four base stations.
You must initiate handset registration on
the handset and on the base station.
1. On the handset
v
¢
Ð
¢
Handset
¢
Register H/Set
s
Select base station, e.g.
Base 1
and press
OK
.
~
Enter the system PIN of the
base station (the default is
0000) and press
OK
.
In the display you will see for
example
Base 1
flashing.
2. On the base station
Please refer to the operating instructions
for the base station to find out how to
initiate handset registration on the base
station.
SL 74 on data-enabled ISDN base
stations
(CXxxx/SXxxx-series and SLX740isdn base
stations)
Your handset automatically registers on
data-enabled ISDN base stations
twice
for
faster transmission of MMS messages:
u
Once as handset, e. g.
Internal 11
.
u
Once as data module, e. g.
INT
41:PC 41
.
a
b
