11
Gigaset E560HX / LHSG IE-UK en / A31008-M2766-L101-1-7619 / operating.fm / 9/27/16
Te
mplat
e
G
o
, V
e
rs
ion 1
, 01.
07
.2
014
/ M
odu
leV
e
rs
ion 1
.0
Getting to know your telephone
Volume keys
During a call or when listening to a message, set the volume for the
receiver/headset
or
speaker
or in the case of an incoming call, set the volume of the
ringtone
(5 levels).
¤
Press the volume keys on the right side of the handset:
(louder) /
(quieter)
The current setting is permanently saved after approx.
two seconds (
Extra-loud function
¤
Press the top volume key
until you reach the highest
level.
The extra-loud setting only applies for the duration of the call.
Direct dialling keys A to D
You can save important phone numbers that you call often to the four
direct dialling keys
. You
can assign an
external phone number
to each direct dialling key.
To dial these saved numbers, press the relevant direct dialling key
to
.
You can also assign the emergency function to
direct dialling key
(
Assigning a function to direct dialling keys
Prerequisite:
The direct dialling key in question has not already been assigned a function.
¤
In idle status, press the direct dialling key (
to
) on the handset to which you wish to
assign a function.
Select the relevant function using
:
Volume:
Back
OK
•
At its highest level, the handset exceeds the defined maximum volume in
CAT-iq2.0 for a person with "normal hearing". Nevertheless, even at the extra-loud
setting, the call can continue to be carried out at the best quality.
•
This setting can result in harm to health in persons with a normal hearing ability
and is only intended for persons with a hearing impairment or reduced hearing.
•
Disruptive noises on the phone line can be increased.
¤
Label with Ext. No.
Enter an external phone number directly.
¤
Enter the number and press
OK
.
¤
Enter the name and press
OK
.
¤
Label with internal No.
Direct dial to a handset registered to the same base.
If more than one other handset is registered:
Select handset
OK
¤
Label with Call All Int.
Direct dial to all handsets registered to the same base.
¤
Label with Dir. Number
Label the key with a number from the directory. The directory is
opened. Select a number and press
OK
.
